body lift question

[Rockcrawlintoy]

do you think it would be ok to make one out of alumnium?

Drew

[Daniel]

Drew,
If your talking about making your own thats questionable,i,e.what stock you use and such.
I have seen them made from aluminum stock (round)/machined down to the correct size for the body mount points on quite a few trucks around here so I don`t see any harm in it.
hope that helps out :D
Daniel

[AZWILDYOAT]

Yeah it would be ok, I have seen them before.

[Rockcrawlintoy]

i just measured out the lift pucks from another toyota and machined them to the right size. i just need to part them and drill a hole. i am only doin a 1 incher lol so i figured ill make my own. if i need more ill just buy a 2 inch one

Drew