Warning!!!! Warning!!!! Danger!!! Danger!!!

[richpblaze]

Some piece of shit triied to steal my rig this morning. Thank GOD for my Viper car alarm, the amazing thing is it continued to sound off after the ****************************s cut almost every wire under the hood including neg. battery cable. So I guess I'll be spending the next few days rewiring my rig. Thought I'd post a warning for those of you in the Salt Lake area. I woke up a few minutes to late,I guess it's agood thing, cause if I would have caught the fawkers I'd probably be heading to the Penn. I guess I should look at the bright side at least I have a rig to rewire.:mad: :mad: :mad: :mad: BLAZE

[Travota_85]

Shit man that sux:(

[84 4Runner]

That sucks! I'm glad they didn't get your rig! Nothing is worse than waking up in the morning and finding your rig gone. :(

[richpblaze]

Originally posted by 85Runner
While you're rewiring throw in a kill switch or two.

Thats the good thing about the Viper alarm, once the alarm has been activated you can't start it even with the key. Blaze

:p :p :p Good thing the stupid bastards didn't know what they where doing.

[Toyota crawlin]

Well It's time to put it in the car hole!!!:eek:

[richpblaze]

Originally posted by Toyota crawlin
Well It's time to put it in the car hole!!!:eek:

Yeah the wifes car just lost dibs on the garage for sure. Now the 4-Runner will never see another cold night. BLAZE

[TNToy]

Originally posted by richpblaze
Thats the good thing about the Viper alarm, once the alarm has been activated you can't start it even with the key. Unless they come back with a guy who actually knows what the hell he's doing. Car alarm's Starter Kills are a joke.

Install a fuel-pump kill switch or something similar ASAP. ;)

[richpblaze]

It's 10:30 pm 2 days later, every plug and cut wire have been soldered and heat shrinked, had to replaced both batt. cables. Got in it fired right up, I pushed the gas peddle and the throttle stuck. THE FAWKIN BASTARDS even cut the throttle cable and speedometer cable. Oh well I guess at least it fired right up and I still have a rig. One more trip to the Toyota store and I'll be back on the road. BLAZE:D :D :D

[richpblaze]

:D :D :D :D :D You can 't keep a good toy down. I am throwing a knock sensor code, any suggestions ?????? Blaze

[Possum]

That is why I keep my rig in my shop at all times....

[85tanker]

pull your EFI chip for like 30 sec to clear all of the codes, then see if it stil does it, cutting all those wires could have tripped it, but if u already cleared it and it went again, i cant help you, never really dealt with the knock sensor too much.

[richpblaze]

I have reset the comp. and it is still throwing the code. It runs fine so I will talk to some bros at Toyota and find out what's up thanks.
Blaze

[Cruiser]

this is were you install the flame througher to your alarm!!!


:D :D fry them~!!!!!

as for the censor....FIX IT....DUH!!!!:p :p

[Rescue]

I got stolen my rig once but it was found later! Any way in my runner now I have 2 kill switches a steering wheel club and my best mod yet:

I did a custom hood lock. i put a plate in the hood with a swivel flat bar that goes all the way through the front grille and in back of my bumper where i lock it with a lockable tow pin.

This way the theives will have to pry and scrap the hood to hell before cutting any wires. which by then they will have made too much noise...

Another thing you can do: put a motion detector pointing your truck but instead of lighting a light outside put the light it in your bed room or a buzzer. This way the thief wont be alerted and you can catch him red handed or even call the cops!!