HELP! Front locker install

[YellowJacket]

I was just wondering if there has been anything written up about installing a front locker in a solid axle Toy. I actually know how to install it in the third member and how to put it in the rear, but the front is going to be a little harder. Any tech articles about exactly how to take out the front axles and exactly what I have to disconnect? Tried searching, but couldn't find anything.

[Travota_85]

when I pulled my third members we just started taking everything off from the outside in and put it in individual plastic bags so we knew witch part went where. Its not that hard just takes time, once you start taking it apart theres really only on route you can go.

[msj]

Here (http://www.birfield.com/~morgan/tech/axle/part1.html)
and
Here (http://www.4x4wire.com/toyota/maintenance/front_end/reassembly/)

[Oatmeal]

Get a good repair manual and do it step by step. It's not hard, just really messy!:eek:

[YellowJacket]

By the way guys, Thanks! I did end up getting it installed and before Yotafari. Your right, it wasn't that hard. It's just a lot easier with the tires off!! I found my lug nut key...

[YellowJacket]

Ya, that 4x4wire article is exactly what I was looking for!